My other complaint is that the clamp doesn’t hold the stand in a really stable way. It’s stable enough I suppose, but it’s basically just barely held in there. You put the end of the stand, which is a short pole, into a holder that is far too wide for it and clamp that down with a screw. It really just BARELY makes it stable enough. You could still easily pull it out of the holder and scratch all the paint off of it at the same time and also scrape the paint off while swiveling it a bit in the holder.

On top of the clamp holder being like this, the stand, at least at first, is very hard to move around as it’s a bit stiff. It loosens up quickly, so that’s not something I can complain about, but the issue is that because it’s so stiff, you need to use a lot of force to move it around at first and can easily end up pulling it out of the holder a few times.

These are just some issues I ran into, but they haven’t been a deal breaker for me. It’s extremely solid in construction and has a good range of motion. It is also able to support my Blue Yeti microphone without dangling or standing up straight. It really does a good job.

First and foremost, the build of this mic arm is solid and heavy-duty, living up to its promise of being robust and durable. It effortlessly holds my microphone in place without any wobbling or sagging, even when extended to its maximum length. This level of stability ensures that I can focus entirely on my content without worrying about any unexpected audio disturbances.

Adjustability is another standout feature of the InnoGear Mic Arm. The multiple adjustment points allow for precise positioning of the microphone, ensuring optimal sound capture. Whether I’m recording a podcast, voiceover, or musical performance, I can easily maneuver the mic arm to find the perfect angle and distance, enhancing the overall quality of my recordings.

Installation was surprisingly hassle-free, thanks to the clear and straightforward instructions provided. The clamp mechanism securely attaches to my desk without leaving any marks or damage, and it has proven to be quite versatile, accommodating various desk thicknesses.

One of the aspects I appreciate most is the built-in cable management system. It keeps my recording area neat and organized, preventing any unwanted cable clutter. This attention to detail speaks to the thoughtful design of the InnoGear Mic Arm.

Overall, the InnoGear Microphone Arm Stand has exceeded my expectations in terms of quality and functionality. It’s a reliable and sturdy addition to my recording setup.

Pros:
1. STIFF! It doesn’t appear to be the typical springy arm. You muscle it into position and it stays exactly where you set it.
2. Well built. Doesn’t squeak, paint is good, materials are tough steel. Everything moves smoothly!
3. Packaging is just basic cardboard with a label, and it comes with Velcro straps, desk mounting clamp, and a warranty card. It doesn’t really need instructions but it also has that as well.
4. Price! For what it is, I don’t see any reason to get the Rode arm over this if you’re trying to save some money.

Cons:
1. If I had to choose anything, I’d say that it can wobble a bit once it’s mounted in its base clamp. I think that’s something that can be easily rectified by stuffing a little paper or something in the mounting hole to make it a tighter fit.
2. The 5/8″ microphone adapter could use some sort of texture so that it can be actually tightened a little bit because as it is now, you reach the last thread and it stops. So if you slightly move your mic back it will loosen again. This can be a problem for depending on how you position your mic relative to its mounting point. It can be tightened with pliers but I feel like it should have SOME texture to grab it and tighten it.

Take everything I said with a grain of salt as I just received and set it up. I will revisit after some time passes if need be.